What are the general forms of boarding bridges?

　　What are the general forms of boarding bridges?

　　1. Embedded boarding bridge

　　Embedded boarding bridge, as the name implies: it refers to the boarding bridge embedded with loading and unloading operation platform, the surface of the installed boarding bridge and loading and unloading operation platform is horizontal. Completely integrated into the platform, do not need loading and unloading operations, will not affect other tasks on the platform. This structure of the boarding bridge is currently very widely used and is a relatively fast boarding aid. It is usually designed as early as the structural design of the building has been fully regulated.

　　2. One-side boarding bridge

　　Platform side boarding bridge is installed directly on the front edge of the loading platform. There is no need to excavate or reserve pits on the loading and unloading platform, and the building structure is basically unchanged. The construction factors of loading and unloading operations are not taken into account in the construction, and the side boarding bridge acts as a remedial solution, which can also meet the requirements of entering the truck compartment for loading and unloading operations. Platform side boarding bridge is also designed according to different site conditions, there are a variety of structural forms. It can also be adjusted upward (below the platform) or downward (below the platform) within a certain range, which can meet the installation and use of most loading and unloading platforms.

　　3.Mobile boarding bridge

　　It is suitable for places without loading and unloading platform or need to move loading and unloading. If there is no loading and unloading platform at the logistics site, as a remedial measure, mobile boarding bridge is one of the very suitable solutions. Mobile boarding bridge is equivalent to a mobile steel ramp, forklift can also directly drive into the interior of the truck car for batch loading and unloading. Only one person is needed to operate it, no power supply is required, and safe and fast cargo loading and unloading can be achieved.

　　4. Fixed boarding bridge

　　Fixed boarding bridge is a special auxiliary equipment to realize rapid loading and unloading of goods. Its height adjustment function can set up a bridge between the truck and the goods platform of the warehouse, and forklifts and other mobile goods can be loaded and unloaded in bulk inside with only a single operation. It makes the enterprise reduce a lot of labor, improve the working efficiency and gain greater economic benefits.

　　Features: easy unloading, high stability and low maintenance cost. It is suitable for all kinds of vehicle loading and unloading places and places where traffic is relatively busy. Loading and unloading platform, lifting platform, unloading platform; anti-skid vehicle device, the device is made of steel plate welding.

　　Anti-collision block: this device can effectively protect buildings and boarding bridges from damage. It is made of high tensile strength reinforced rubber. The outer corners of the anti-collision block are rounded and the bolt holes are all deeply embedded inside.

　　Structure: The fixed boarding bridge is composed of mechanical system, hydraulic system and electrical system. Platform and base constitute the mechanical system. The platform adopts "U" type steel frame, with light self-weight and large load-bearing capacity; the table adopts anti-skid patterned steel plate, with large load-bearing capacity. The working platform adopts non-slip patterned steel plate, which can withstand forklift running speed of 10km/h without concave bending, and improve the reliability of work.